Keywords: The use and comprehensive utilization of shredders

The installation of a claw type crusher for processing miscellaneous grains and crushing feed can be carried out indoors, installed on the site, or installed on a vehicle for mobile processing. Installation is simple and does not require a solid foundation or other auxiliary equipment. When the motor is used for driving, the motor can be directly installed on the motor base. When other power is used, the intermediate drive Shaft-driven bicycle can be used for driving or the pulley can be replaced. Because the crusher mainly relies on the moving teeth to strike and break, the impact force of the moving teeth on the material must greatly exceed the binding force of the material itself. The faster the rotating speed of the moving tooth disc, the greater the kinetic energy generated by the moving teeth, and the higher the production efficiency. But beyond a certain range, the useless power consumed by the machine itself increases, and the production efficiency will decrease. Therefore, it is necessary to equip the belt pulley according to the specified speed. Experiments have shown that the linear speed of flat teeth is better between 80 and 90 meters per second.

When processing corn, sorghum, soybeans, and other grains in a shaker, the grains to be processed are placed in a hopper, and the insertion plate is lifted. The grains will automatically flow into the crushing chamber, and the size of the flow depends on the height of the upward lifting position of the insertion plate. Adjust the hopper when crushing soybean cakes, sweet potatoes, and other block shaped ingredients. When crushing long stalked feed such as corn straw and straw, the long stalked feed hopper should be replaced.

The grain and feed to be processed should be carefully cleaned and fed evenly after the machine is started. Strictly prevent hard objects such as metals from entering the machine to avoid accidents caused by damaging the fixed teeth, sieve, and moving teeth.

The control of twist fineness and the installation of sieves to crush the coarseness of materials are controlled by replacing different sieve plates with different pore sizes. Each model of crusher is equipped with thirteen different sieve plates with different pore sizes. According to the needs of processing materials, users can choose to purchase screen pieces and screw out the screen ring screws to replace the screen pieces. When replacing the screen, two issues need to be noted: firstly, each screw should be evenly tightened to keep the two screen rings parallel, so that there will be no leakage after being installed in the machine; Secondly, due to the fact that the sieve is punched with slightly tapered circular holes, small burred surface aperture, and large smooth surface aperture, it is necessary to install the sieve with burrs facing inward and smooth facing outward, so that any fine powder entering the sieve can be discharged outside the machine. Conversely, some small particles will block the sieve hole, reducing the screening area and greatly reducing production efficiency.

When installing a sieve into the machine body, the overlapping method at the joint of the sieve should be correctly selected based on the rotation direction of the moving tooth plate, so that the joint at the inner end of the sieve plate follows the rotation direction of the moving tooth plate. When processing coarse grains and feed, the processed fine powder is discharged to the outside of the machine through the discharge port, and the fine powder is collected secretly outside the discharge port. There are usually two methods. One type is a cloth bag with openings at both ends, which has a diameter of about 1 city foot and a length of 8 city feet. The fabric pattern should not be too dense, as it will not enter the air and reduce productivity. During work, place the opening of one end of the cloth bag over the discharge port, then tie it tightly with tape or rope, and tie the other end with a thin rope. The processed materials can be stored in the dough bag at any time and can work continuously without stopping the machine. It is very convenient for flow processing. Another method is to dig a pit in front of the discharge port after the crusher is installed, use bricks to build it, apply cement, and the discharge port should be directly connected to the pit. The upper port of the pit should be covered with a lid to prevent powder from flying